RX 350 FWD V6-3.5L (2GR-FE) (2010)
17. REMOVE REAR DOOR SCUFF PLATE RH
HINT
Use the same procedure for the RH side and LH side See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal and Replacement/Removal.
18. REMOVE REAR SEAT SIDE COVER RH
HINT
Use the same procedure for the RH side and LH side See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal and Replacement/Removal.
19. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
HINT
Use the same procedure for the RH side and LH side See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal and Replacement/Removal.
20. REMOVE ROPE HOOK ASSEMBLY
HINT
Use the same procedure for the RH side and LH side See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal and Replacement/Removal.
21. REMOVE RECLINING REMOTE CONTROL BEZEL RH
HINT
Use the same procedure for the RH side and LH side See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal and Replacement/Removal.
22. REMOVE HEIGHT CONTROL SWITCH (w/ Air Suspension) See: Sensors and Switches/Sensors and Switches - Steering and
Suspension/Sensors and Switches - Suspension/Suspension Mode Switch/Service and Repair/Height Control Switch (for Luggage
Compartment)/Removal
23. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
and Replacement/Removal
24. REMOVE DOOR CONTROL RECEIVER
(a) Disconnect the connector.
(b) Remove the bolt and door control receiver.
From 08/2009
DOOR LOCK: DOOR CONTROL RECEIVER: REMOVAL
1. PRECAUTION (w/ Navigation System for HDD)
NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and