RX 350 FWD V6-3.5L (2GR-FE) (2010)
Engine Control Module: Service and Repair
Installation
Up to 08/2009
2GR-FE ENGINE CONTROL: ECM: INSTALLATION
1. INSTALL ECM
(a) Install the 2 brackets to the ECM with the 5 screws.
Text in Illustration
(b) Install the ECM with bracket with the 3 bolts.
Torque : 8.0 Nm (82 kgf-cm, 70 in-lbf)
(c) Connect the 2 ECM connectors and lower the 2 levers.
NOTICE:
*
When connecting the connectors, make sure that dirt, water or other foreign matter does not become stuck between the connectors
and other part.
*
Make sure that the 2 levers are securely locked.
(d) Install the wire harness clamp.
(e) Install the wire harness clamp.
2. INSTALL AIR CLEANER ASSEMBLY See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and
Repair/Installation
3. INSTALL BATTERY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine Assembly/Installation
4. INSTALL NO. 1 AIR CLEANER INLET See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Installation