RX 350 FWD V6-3.5L (2GR-FE) (2010)
HINT
Pull out the lock of the lock lever, disengage the claw, and raise the lock lever to disconnect the connector as shown in the illustration.
(c) Remove the 2 nuts, clamp and power steering ECU assembly.
(d) Remove the relay block sub-assembly.
From 08/2009
POWER ASSIST SYSTEMS: POWER STEERING ECU: REMOVAL
CAUTION:
Be sure to read Precaution thoroughly before servicing See: Steering and Suspension/Steering/Service Precautions/Power Steering
System.
1. FRONT WHEELS FACING STRAIGHT AHEAD
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
3. REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY
HINT
Refer to the instructions for Removal of the brake pedal support sub-assembly See: Brakes and Traction Control/Brake Pedal
Assy/Service and Repair/Removal and Replacement/Removal.
4. REMOVE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
(a) Disconnect the connectors from the instrument panel junction block assembly and power management control ECU.
(b) Remove the 2 nuts.