RX 350 FWD V6-3.5L (2GR-FE) (2010)
Tire Pressure Module: Service and Repair
Installation
Up to 08/2009
TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING ECU: INSTALLATION
1. INSTALL TIRE PRESSURE WARNING ECU
(a) Connect the connector.
(b) Engage the 2 claws to install the tire pressure warning ECU.
HINT
Slide the tire pressure warning ECU towards the front of the vehicle to install it.
2. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Installation
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
4. REGISTER OF TRANSMITTER ID
HINT
It is necessary to register all transmitter IDs See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring
System/Testing and Inspection/Programming and Relearning/Registration.
5. INSPECT TIRE PRESSURE WARNING SYSTEM
(a) Inspect the tire pressure warning system See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring System/Testing and
Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure.
From 08/2009
TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING ECU: INSTALLATION
1. INSTALL TIRE PRESSURE WARNING ECU
(a) Connect the connector.