RX 350 FWD V6-3.5L (2GR-FE) (2010)
/Page-2456022.png)
SST wire harness inside the tire.
(2) Move SST at least 10 m (32.8 ft.) away from the airbag tied down to the tire.
(g) Deploy the airbag.
(1) Connect the red clip of SST to the positive (+) battery terminal and the black clip of SST to the negative (-) battery terminal.
(2) Check that no one is within a 10 m (32.8 ft.) radius of the tire to which the front passenger side knee airbag assembly is tied.
(3) Press the SST activation switch and deploy the airbag.
CAUTION:
Before deployment, make sure that no one is near the airbag.
HINT
The airbag is deployed as the LED of the SST activation switch comes on.
(h) Dispose of the front passenger side knee airbag assembly.
CAUTION:
*
The front passenger side knee airbag assembly becomes extremely hot when the airbag is deployed, so do not touch it for at least
30 minutes after deployment.
*
Use gloves and safety glasses when handling a front passenger side knee airbag assembly with a deployed airbag.
*
Do not apply water etc. to a front passenger side knee airbag assembly with a deployed airbag.
*
Always wash your hands with water after completing the operation.
(1) Remove the front passenger side knee airbag assembly from the tire.
(2) Place the front passenger side knee airbag assembly in a plastic bag, tie it tightly, and dispose of it according to local regulations.
Up to 08/2009
SUPPLEMENTAL RESTRAINT SYSTEMS: CURTAIN SHIELD AIRBAG ASSEMBLY: DISPOSAL
CAUTION:
Before performing pre-disposal deployment of any SRS part, review and closely follow all applicable environmental and hazardous
material regulations. Pre-disposal deployment may be considered hazardous material treatment.
1. PRECAUTION
CAUTION:
*
An airbag or pretensioner may be activated by static electricity. To prevent this, be sure to touch a metal surface with your bare
hands to discharge static electricity before performing this procedure.
*
Never dispose of a curtain shield airbag assembly with an undeployed airbag.
*
The airbag produces an exploding sound when it is deployed, so perform the operation outdoors and where it will not create a
nuisance to nearby residents.
*
When deploying the airbag, always use the specified SST (SRS Airbag Deployment Tool). Perform the operation in a place away
from electrical noise.
*
When deploying the airbag, perform the operation at least 10 m (32.8 ft.) away from the curtain shield airbag assembly.
*
The curtain shield airbag assembly becomes extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes
after deployment.
*
Use gloves and safety glasses when handling a curtain shield airbag assembly with a deployed airbag.
*
Do not apply water etc. to a curtain shield airbag assembly with a deployed airbag.
*
Always wash your hands with water after completing the operation.
HINT
