RX 350 FWD V6-3.5L (2GR-FE) (2010)
NOTICE:
*
When connecting any airbag connector, take care not to damage the airbag wire harness.
*
Be sure to only connect the connectors to each corresponding color.
(b) Push in the lock to install the airbag connector.
(c) Engage the clamp to install the instrument panel wire assembly to the front passenger airbag assembly.
2. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY
(a) Engage the 5 hooks.
(b) Push the front passenger airbag assembly to engage the 5 hooks.
(c) Engage the 2 pins.
(d) Install the 2 screws to install the front passenger airbag assembly.
Text in Illustration
3. INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Installation
4. CONNECT INSTRUMENT PANEL WIRE ASSEMBLY
(a) Check that the engine switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Connect the connector.