RX 350 FWD V6-3.5L (2GR-FE) (2010)
HINT
Use the same procedure for the RH side and the LH side See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Removal.
6. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Removal
7. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Removal
8. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Removal
9. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Removal
10. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY
CAUTION:
When storing the front passenger side knee airbag assembly, keep the airbag deployment side facing upward.
(a) Check that the engine switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Put protective tape around the front passenger side knee airbag assembly.
Text in Illustration
(d) Remove the 3 bolts.
(e) Disengage the claw and 2 pins to separate the front passenger side knee airbag assembly.
(f) Using a screwdriver with the tip wrapped with protective tape, disconnect the airbag connector to remove the front passenger side knee airbag
assembly.
Text in Illustration