lexus Workshop Repair Guides

Lexus Workshop Service and Repair Manuals

Procedures|Page 9747 > < Procedures|Page 9745
Page 21
background image

CAUTION:
When storing the front passenger side knee airbag assembly, keep the airbag deployment side facing upward.

(a) Check that the engine switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Put protective tape around the front passenger side knee airbag assembly.

Text in Illustration

(d) Remove the 3 bolts.

(e) Disengage the claw and 2 pins to separate the front passenger side knee airbag assembly.

(f) Using a screwdriver with the tip wrapped with protective tape, disconnect the airbag connector to remove the front passenger side knee airbag

assembly.

Text in Illustration

NOTICE:
When disconnecting the airbag connector, take care not to damage the airbag wire harness.

Up to 08/2009

SUPPLEMENTAL RESTRAINT SYSTEMS: KNEE AIRBAG ASSEMBLY (for Front Passenger Side): INSTALLATION

1. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY

(a) Check that the engine switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

Procedures|Page 9747 > < Procedures|Page 9745