RX 350 FWD V6-3.5L (2GR-FE) (2010)
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Connect the airbag connector to the front passenger side knee airbag assembly.
NOTICE:
When connecting the airbag connector, take care not to damage the airbag wire harness.
(d) Temporarily install the front passenger side knee airbag assembly with the claw and 2 pins.
(e) Install the front passenger side knee airbag assembly with the 3 bolts.
Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)
NOTICE:
Confirm that the front passenger side knee airbag assembly is installed securely without any excessive gaps and is not protruding
outward.
(f) Remove the protective tape.
Text in Illustration
2. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Installation
3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Installation
4. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service
and Repair/Removal and Replacement/Installation
5. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Installation
6. INSTALL INSTRUMENT PANEL GARNISH RH
HINT
Use the same procedure for the RH side and the LH side See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Installation.