RX 350 FWD V6-3.5L (2GR-FE) (2010)
Air Bag: Testing and Inspection
Rear Seat Side Airbag Assembly
Up to 08/2009
SUPPLEMENTAL RESTRAINT SYSTEMS: REAR SEAT SIDE AIRBAG ASSEMBLY: ON-VEHICLE INSPECTION
CAUTION:
Be sure to follow the correct removal and installation procedures of the rear seat assembly.
1. INSPECT REAR SEAT SIDE AIRBAG ASSEMBLY (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC Check / Clear.
(b) Visually check for defects with the rear seat side airbag assembly installed on the vehicle.
(1) The defects are as follows:
*
Cuts on the rear seatback assembly around the rear seat side airbag assembly
*
Small cracks on the rear seatback assembly around the rear seat side airbag assembly
*
Significant discoloration on the rear seatback assembly around the rear seat side airbag assembly
OK:
No defects are found.
HINT
If any of the defects is found, replace the rear seat assembly with a new one.
2. INSPECT REAR SEAT SIDE AIRBAG ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)
(a) Perform a diagnostic system check See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC Check / Clear.
(b) Visually check for defects with the rear seat side airbag assembly removed from the vehicle.
(1) The defects are as follows:
*
Cuts on the surface of the rear seat side airbag assembly
*
Small cracks on the surface of the rear seat side airbag assembly
*
Marks from being dropped
*
Deformation on the installation part of the rear seat side airbag assembly
*
Cracks or other damage to the wire harness or connector
OK:
No defects are found.