RX 350 FWD V6-3.5L (2GR-FE) (2010)
(c) Rotate the spiral cable counterclockwise slowly by hand until it stops.
NOTICE:
Do not turn the spiral cable using the airbag wire harness.
(d) Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.
Text in Illustration
NOTICE:
Do not turn the spiral cable using the airbag wire harness.
HINT
The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.
6. INSTALL STEERING WHEEL ASSEMBLY See: Steering and Suspension/Steering/Steering Wheel/Service and Repair/Installation
7. INSPECT STEERING WHEEL CENTER POINT
8. INSTALL STEERING PAD See: Air Bag/Service and Repair/Removal and Replacement/Steering Pad/Installation
9. INSTALL LOWER NO. 3 STEERING WHEEL COVER See: Air Bag/Service and Repair/Removal and Replacement/Steering Pad/Installation
10. INSTALL LOWER NO. 2 STEERING WHEEL COVER See: Air Bag/Service and Repair/Removal and Replacement/Steering Pad/Installation
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL See: Steering and Suspension/Steering/Steering Column/Service and
Repair/Removal and Replacement/Installation
12. INSPECT STEERING PAD See: Air Bag/Service and Repair/Removal and Replacement/Steering Pad/Installation
13. PERFORM DIAGNOSTIC SYSTEM CHECK
(a) Perform a diagnostic system check See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC Check / Clear.
14. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System.
From 08/2009
SUPPLEMENTAL RESTRAINT SYSTEMS: SPIRAL CABLE: INSTALLATION
1. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
NOTICE:
*
Do not replace the spiral cable with the battery connected and the engine switch on (IG).
*
Do not rotate the spiral cable with the battery connected and the engine switch on (IG).
*
Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.