RX 350 FWD V6-3.5L (2GR-FE) (2010)
w/ Navigation System for HDD:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Removal
4. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Removal
5. REMOVE NO. 2 CONSOLE BOX DUCT See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and
Replacement/Removal
6. REMOVE INSTRUMENT PANEL GARNISH LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Removal
7. REMOVE NO. 1 SWITCH HOLE BASE See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Removal
8. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Removal
9. REMOVE INSTRUMENT PANEL FINISH PANEL See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Removal
10. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Removal
11. REMOVE CONSOLE REAR END PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and
Repair/Removal and Replacement/Removal
12. REMOVE MULTI-MEDIA INTERFACE ECU ASSEMBLY (w/ USB Audio System) See: Accessories and Optional Equipment/Entertainment
Systems/Entertainment System Control Module/Service and Repair/Multi-Media Interface ECU/Removal
13. REMOVE REAR CONSOLE BOX ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and
Replacement/Removal
14. REMOVE CONSOLE BOX See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Removal and
Replacement/Removal
15. REMOVE CENTER AIRBAG SENSOR ASSEMBLY
(a) Check that the engine switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Disconnect the connector from the center airbag sensor assembly as shown in the illustration.