RX 350 FWD V6-3.5L (2GR-FE) (2010)
SST : 09961-00950
without SST - Torque : 18 Nm (178 kgf-cm, 13 ft-lbf)
with SST - Torque : 11 Nm (112 kgf-cm, 8 ft-lbf)
NOTICE:
*
Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
*
This torque value is effective when SST is parallel to a torque wrench.
*
If the center airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector,
replace it with a new one.
*
When installing the center airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched
between other parts.
*
When the engine switch is first turned on (IG) after the center airbag sensor assembly has been replaced, make sure that no one is
in the vehicle.
(d) Connect the connector to the center airbag sensor assembly as shown in the illustration.
NOTICE:
When connecting the airbag connector, take care not to damage the airbag wire harness.
(e) Check that the waterproof sheet is properly set.
(f) Check that there is no looseness in the installation parts of the center airbag sensor assembly.
2. INSTALL CONSOLE BOX See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Removal and
Replacement/Installation
3. INSTALL REAR CONSOLE BOX ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and
Replacement/Installation
4. INSTALL MULTI-MEDIA INTERFACE ECU ASSEMBLY (w/ USB Audio System) See: Accessories and Optional Equipment/Entertainment
Systems/Entertainment System Control Module/Service and Repair/Multi-Media Interface ECU/Installation
5. INSTALL CONSOLE REAR END PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and
Repair/Removal and Replacement/Installation
6. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Installation
7. INSTALL INSTRUMENT PANEL FINISH PANEL See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Installation
8. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Installation
9. INSTALL NO. 1 SWITCH HOLE BASE See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Installation
10. INSTALL INSTRUMENT PANEL GARNISH LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Installation
11. INSTALL NO. 2 CONSOLE BOX DUCT See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and
Replacement/Installation
12. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service
and Repair/Removal and Replacement/Installation
13. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Installation