RX 350 FWD V6-3.5L (2GR-FE) (2010)
*
If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with
a new one.
*
When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with or is not pinched between other
parts.
*
Make sure that the pin (stopper) is securely inserted into the body hole.
*
Tighten the nut while holding the rear airbag sensor because the rear airbag sensor pin (stopper) is easily damaged.
(d) Connect the connector to the rear airbag sensor.
NOTICE:
When connecting the airbag connector, take care not to damage the airbag wire harness.
(1) Connect the connector as shown in the illustration (when locking, make sure that the outer connector locking sleeve returns to its original
position and a click sound can be heard).
Text in Illustration
HINT
When connected, the outer connector locking sleeve will slide. Be sure not to hold the outer connector locking sleeve while connecting,
as it may result in an insecure fit.
(e) Check that there is no looseness in the installation parts of the rear airbag sensor.
2. INSTALL REAR SEAT SIDE COVER See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
3. INSTALL REAR DOOR SCUFF PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
4. INSTALL REAR SEAT ASSEMBLY
HINT
Refer to the procedure from Install Rear Seat Assembly See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Rear Seat Assembly (for LH Side)/Installation for LH Side, See: Body and Frame/Seats/Service and Repair/Removal
and Replacement/Rear Seat Assembly (for RH Side)/Installation for RH Side).
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
6. PERFORM DIAGNOSTIC SYSTEM CHECK
(a) Perform a diagnostic system check See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC Check / Clear.
7. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System.