RX 350 FWD V6-3.5L (2GR-FE) (2010)
(a) Perform a diagnostic system check See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC Check / Clear.
10. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System.
From 08/2009
SUPPLEMENTAL RESTRAINT SYSTEMS: OCCUPANT CLASSIFICATION ECU: INSTALLATION
1. INSTALL OCCUPANT CLASSIFICATION ECU
(a) Install the occupant classification ECU with the claw.
NOTICE:
If the occupant classification ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace
the occupant classification ECU with a new one.
(b) Engage the 3 claws to install the 2 connectors and wire harness holder.
Text in Illustration
(c) Install the 6 clamps.
(d) Connect the 4 connectors.
NOTICE:
When installing the occupant classification ECU, be careful that the SRS wiring does not interfere with or is pinched between other
parts.
2. INSTALL FRONT SEAT ASSEMBLY RH
HINT
Use the same procedure for the RH side and LH side See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Front Seat Assembly/Installation.
3. INSTALL REAR OUTER SEAT TRACK BRACKET COVER RH
HINT
Use the same procedure for the RH side and LH side See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Front Seat Assembly/Installation.