RX 350 FWD V6-3.5L (2GR-FE) (2010)
NOTICE:
Do not allow the anchor part of the front seat inner belt assembly to overlap the protruding part of the front seat adjuster.
(b) Connect each connector and clamp.
2. INSTALL FRONT SEAT ASSEMBLY
(a) Install the front seat assembly See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front Seat Assembly/Installation.
Components
SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: COMPONENTS
Up to 08/2009
SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: REMOVAL
1. PRECAUTION (w/ Navigation System for HDD)
NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
3. REMOVE FRONT DOOR SCUFF PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Removal
4. REMOVE REAR DOOR SCUFF PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and