RX 350 FWD V6-3.5L (2GR-FE) (2010)
HINT
When connected, the outer connector locking sleeve will slide. Be sure not to hold the outer connector locking sleeve while connecting,
as it may result in an insecure fit.
(e) Check that there is no looseness in the installation parts of the rear airbag sensor.
2. INSTALL REAR SEAT SIDE COVER See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
3. INSTALL REAR DOOR SCUFF PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
4. INSTALL REAR SEAT ASSEMBLY
HINT
Refer to the procedure from Install Rear Seat Assembly See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Rear Seat Assembly (for LH Side)/Installation for LH Side, See: Body and Frame/Seats/Service and Repair/Removal
and Replacement/Rear Seat Assembly (for RH Side)/Installation for RH Side).
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
6. PERFORM DIAGNOSTIC SYSTEM CHECK
(a) Perform a diagnostic system check See: Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC
Check / Clear.
7. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light See: Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System.
From 08/2009
SUPPLEMENTAL RESTRAINT SYSTEMS: REAR AIRBAG SENSOR: INSTALLATION
HINT
*
Use the same procedure for the RH side and LH side.
*
The procedure listed below is for the LH side.
1. INSTALL REAR AIRBAG SENSOR
(a) Check that the engine switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Insert the pin (stopper) into the body hole to install the rear airbag sensor to the vehicle with the nut.
Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)