RX 350 FWD V6-3.5L (2GR-FE) (2010)
Impact Sensor: Service and Repair
Side Airbag Sensor (for Rear Side)
Components
SUPPLEMENTAL RESTRAINT SYSTEMS: SIDE AIRBAG SENSOR (for Rear Side): COMPONENTS
Up to 08/2009
SUPPLEMENTAL RESTRAINT SYSTEMS: SIDE AIRBAG SENSOR (for Rear Side): REMOVAL
HINT
*
Use the same procedure for the RH side and LH side.
*
The procedure listed below is for the LH side.
1. PRECAUTION
CAUTION:
Be sure to read Precaution thoroughly before servicing See: Air Bag Systems/Service Precautions.
NOTICE:
w/ Navigation System for HDD:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
3. REMOVE FRONT DOOR SCUFF PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Removal
4. REMOVE REAR DOOR SCUFF PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Removal
5. REMOVE LOWER CENTER PILLAR GARNISH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Removal
6. REMOVE SIDE AIRBAG SENSOR