RX 350 FWD V6-3.5L (2GR-FE) (2010)
/Page-2586004.png)
Loosen the bolt while holding the side airbag sensor because the side airbag sensor pin (stopper) is easily damaged.
Up to 08/2009
SUPPLEMENTAL RESTRAINT SYSTEMS: SIDE AIRBAG SENSOR (for Rear Side): INSTALLATION
HINT
*
Use the same procedure for the RH side and LH side.
*
The procedure listed below is for the LH side.
1. INSTALL SIDE AIRBAG SENSOR
(a) Check that the engine switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Insert the pin (stopper) into the body hole to install the side airbag sensor to the vehicle with the bolt.
Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)
NOTICE:
*
If the side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with
a new one.
*
When installing the side airbag sensor, be careful that the SRS wiring does not interfere with or is not pinched between other
parts.
*
Make sure that the pin (stopper) is securely inserted into the body hole.
*
Tighten the bolt while holding the side airbag sensor because the side airbag sensor pin (stopper) is easily damaged.
(d) Connect the connector to the side airbag sensor.
NOTICE:
When connecting the airbag connector, take care not to damage the airbag wire harness.
(1) Connect the connector as shown in the illustration (when locking, make sure that the outer connector locking sleeve returns to its original
position and a click sound can be heard).
Text in Illustration
HINT
When connected, the outer connector locking sleeve will slide. Be sure not to hold the outer connector locking sleeve while connecting,
as it may result in an insecure fit.
(e) Check that there is no looseness in the installation parts of the side airbag sensor.
2. INSTALL LOWER CENTER PILLAR GARNISH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
