RX 350 FWD V6-3.5L (2GR-FE) (2010)
(b) Disengage the 2 claws (A) and separate the 2 connectors.
(c) Remove the 6 clamps.
(d) Disengage the claw (B) and separate the wire harness holder as shown in the illustration.
Text in Illustration
(e) Using a screwdriver with the tip wrapped with protective tape, disengage the claw to remove the occupant classification ECU.
Text in Illustration
Up to 08/2009
SUPPLEMENTAL RESTRAINT SYSTEMS: OCCUPANT CLASSIFICATION ECU: INSTALLATION
1. INSTALL OCCUPANT CLASSIFICATION ECU
(a) Install the occupant classification ECU with the claw.
NOTICE:
If the occupant classification ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace
the occupant classification ECU with a new one.
(b) Engage the 3 claws to install the 2 connectors and wire harness holder.