RX 350 FWD V6-3.5L (2GR-FE) (2010)
Seat Position Sensor: Service and Repair
Removal
Up to 08/2009
SUPPLEMENTAL RESTRAINT SYSTEMS: SEAT POSITION SENSOR: REMOVAL
1. PRECAUTION
CAUTION:
Be sure to read Precaution thoroughly before servicing See: Air Bag Systems/Service Precautions.
NOTICE:
w/ Navigation System for HDD:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
2. REMOVE FRONT SEAT HEADREST ASSEMBLY LH See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front Seat
Assembly/Removal
3. REMOVE FRONT OUTER SEAT TRACK BRACKET COVER LH See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Front Seat Assembly/Removal
4. REMOVE FRONT INNER SEAT TRACK BRACKET COVER LH See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Front Seat Assembly/Removal
5. REMOVE REAR OUTER SEAT TRACK BRACKET COVER LH See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Front Seat Assembly/Removal
6. REMOVE REAR INNER SEAT TRACK BRACKET COVER LH See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Front Seat Assembly/Removal
7. REMOVE FRONT SEAT ASSEMBLY LH See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front Seat
Assembly/Removal
8. REMOVE SEAT POSITION SENSOR
(a) Disconnect the connector.
(b) Using a T30 "TORX" socket wrench, remove the "TORX" screw and seat position sensor with the seat slide position sensor protector.
(c) Remove the seat position sensor from the seat slide position sensor protector as shown in the illustration.
From 08/2009