RX 350 FWD V6-3.5L (2GR-FE) (2010)
Wheel Speed Sensor: Service and Repair
Front Speed Sensor
Components
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: FRONT SPEED SENSOR: COMPONENTS
Up to 08/2009
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: FRONT SPEED SENSOR: REMOVAL
HINT
*
Use the same procedure for the LH side and RH side.
*
The following procedure is for the LH side.
*
If the sensor rotor needs to be replaced, replace it together with the front drive shaft assembly.
1. PRECAUTION (w/ Navigation System for HDD)
NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
2. PRECAUTION (w/ Air Suspension)
NOTICE:
Be sure to read Precaution thoroughly before servicing See: Steering and Suspension/Suspension/Service Precautions/Suspension
Control System.
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
4. REMOVE FRONT WHEEL
5. REMOVE FRONT SPEED SENSOR
(a) Using a screwdriver, turn the pins 90 degrees and remove the 2 pin hold clips.