RX 350 FWD V6-3.5L (2GR-FE) (2010)
7. PREPARE VEHICLE FOR HEADLIGHT AIM ADJUSTMENT See: Lighting and Horns/Headlamp/Adjustments
8. PREPARE FOR HEADLIGHT AIMING (Using a headlight aim test machine) See: Lighting and Horns/Headlamp/Adjustments
9. PREPARE FOR HEADLIGHT AIMING (Using a screen) See: Lighting and Horns/Headlamp/Adjustments
10. INSPECT HEADLIGHT AIMING See: Lighting and Horns/Headlamp/Adjustments
11. ADJUST HEADLIGHT AIMING See: Lighting and Horns/Headlamp/Adjustments
From 08/2009
LIGHTING (EXT): HEIGHT CONTROL SENSOR: INSTALLATION
1. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY
(a) Install the rear height control sensor sub-assembly with the 2 nuts.
Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)
(b) Engage the guide and install the bolt.
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
(c) Engage the guide and install the bolt.
Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)
(d) Connect the connector.
2. INSTALL REAR WHEEL See: Steering and Suspension/Suspension/Suspension Strut / Shock Absorber/Service and Repair/Removal and
Replacement/Rear Shock Absorber/Installation
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
4. CHECK VEHICLE HEIGHT (w/ Air Suspension)
NOTICE:
If the height control sensor link is removed, check the vehicle height.
(a) Change the height control switch from the "NORM" position to the "HIGH" position and back to the "NORM" position.
(b) Measure the vehicle height See: Maintenance/Alignment/Service and Repair/Front Wheel Alignment.
5. ADJUST VEHICLE HEIGHT (w/ Air Suspension)
NOTICE:
If the height control sensor has been replaced, be sure to adjust the vehicle height.