RX 350 FWD V6-3.5L (2GR-FE) (2010)
NOTICE:
*
Be sure to install the gasket in the correct direction.
*
Do not reuse the gasket.
*
Do not damage the gasket.
*
Do not push in the gasket by using the exhaust pipe when connecting it.
(e) Install 2 new gaskets to the No. 3 front exhaust pipe sub-assembly.
(f) Install the No. 3 front exhaust pipe sub-assembly with the 4 bolts, 2 compression springs and 2 nuts.
Torque : 55 Nm (561 kgf-cm, 40 ft-lbf for the bolt)
Torque : 55 Nm (561 kgf-cm, 40 ft-lbf for the nut)
4. INSTALL OXYGEN SENSOR (for Bank 1 Sensor 2)
(a) Using SST, install the oxygen sensor to the center exhaust pipe assembly.
Text in Illustration
SST : 09224-00010
without SST - Torque : 44 Nm (449 kgf-cm, 33 ft-lbf)
with SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)
NOTICE:
*
The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
*
The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) See: Service
Precautions.
*
The "with SST" torque value is effective when SST is parallel to the torque wrench.
(b) Install the wire harness clamp bracket.