RX 350 FWD V6-3.5L (2GR-FE) (2010)
/Page-549005.png)
^
When a garnish clip is being replaced, make sure to install it in the direction shown in the illustration.
C. Engage the 2 guides.
D. Turn the end of the front pillar garnish clip 90 with needle-nosed pliers and install it to the front pillar garnish.
E. Engage the 2 clips to install the front pillar garnish.
8. Inspect the AF2 connector for corrosion and clean/repair as needed.
9. Clear all DTCs and test drive to verify the repairs.
10. If the MIL "ON" condition continues to occur after this procedure, refer to the Repair Manual for further diagnostic procedures and specifications.
