RX 350 FWD V6-3.5L (2GR-FE) (2010)
Ignition Switch: Service and Repair
Installation
Up to 08/2009
2GR-FE STARTING: ENGINE SWITCH: INSTALLATION
1. INSTALL ENGINE SWITCH
(a) Connect the engine switch connector.
(b) Attach the 2 claws to install the engine switch.
2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Installation
3. INSTALL NO. 1 SWITCH HOLE BASE See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Installation
4. INSTALL INSTRUMENT PANEL GARNISH LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Installation
5. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
and Replacement/Installation
6. INSTALL FRONT DOOR SCUFF PLATE LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
From 08/2009
2GR-FE STARTING: ENGINE SWITCH: INSTALLATION
1. INSTALL ENGINE SWITCH
(a) Connect the engine switch connector.