RX 350 FWD V6-3.5L (2GR-FE) (2010)
Neutral Safety Switch: Adjustments
U660E Automatic Transaxle
Up to 08/2009
U660E AUTOMATIC TRANSMISSION / TRANSAXLE: PARK / NEUTRAL POSITION SWITCH: ADJUSTMENT
1. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(a) Remove the control shaft lever.
HINT
See the steps from "Remove Windshield Wiper Motor and Link Assembly" through "Remove Park/Neutral Position Switch
Assembly" See: Service and Repair/U660E Automatic Transaxle/Removal.
(b) Loosen the 2 bolts of the park/neutral position switch.
(c) Align the protrusions of the park/neutral position switch.
Text in Illustration
(d) Hold the park/neutral position switch in position and tighten the 2 bolts.
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
NOTICE:
After installing the park/neutral position switch, confirm that the 2 protrusions on the switch are aligned.
(e) Install the control shaft lever.
HINT
See the steps from "Install Park/Neutral Position Switch Assembly" through "Install Windshield Wiper Motor and Link Assembly"
See: Service and Repair/U660E Automatic Transaxle/Installation.