RX 350 FWD V6-3.5L (2GR-FE) (2010)
/Page-1839005.png)
(a) Disconnect the connector from the park/neutral position switch.
(b) Remove the nut, washer and control shaft lever from the control shaft.
(c) Remove the 2 bolts and park/neutral position switch from the control shaft.
NOTICE:
Before removing the park/neutral position switch, remove any dirt or rust on the installation portion of the control shaft. Be sure to
remove the switch straight along the shaft while being careful not to deform the plate spring that supports the shaft. If the plate
spring is deformed, the park/neutral position switch cannot be reinstalled correctly.
Up to 08/2009
U660E AUTOMATIC TRANSMISSION / TRANSAXLE: PARK / NEUTRAL POSITION SWITCH: INSTALLATION
1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(a) Move the shift lever to N.
(b) Align the protrusions of the park/neutral position switch.
Text in Illustration
(c) Install the park/neutral position switch to the control shaft with the 2 bolts.
