RX 350 FWD V6-3.5L (2GR-FE) (2010)
/Page-1840006.png)
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
NOTICE:
*
Before installing the park/neutral position switch, remove any dirt or rust on the installation portion of the control shaft. Be sure
to install the switch straight along the shaft while being careful not to deform the plate spring that supports the shaft. If the plate
spring is deformed, the park/neutral position switch cannot be reinstalled correctly.
*
After installing the park/neutral position switch, confirm that the 2 protrusions on the switch are aligned.
(d) Install the control shaft lever to the control shaft with the nut and washer.
Torque : 13 Nm (130 kgf-cm, 9 ft-lbf)
(e) Connect the connector to the park/neutral position switch.
2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Install a new clip to the control cable bracket.
(b) Install the control cable to the control cable bracket.
Text in Illustration
NOTICE:
*
Make sure that the claws A on the clip are securely fit into the bracket holes.
*
Make sure that the cable is securely installed inside of the claws B of the clip.
(c) Connect the transmission control cable to the control shaft lever with the nut.
Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)
