RX 350 FWD V6-3.5L (2GR-FE) (2010)
Steering Column Control Module: Service and Repair
Removal
Up to 08/2009
STEERING COLUMN: MULTIPLEX TILT AND TELESCOPIC ECU: REMOVAL
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system
before servicing See: Restraint Systems/Air Bag Systems/Service Precautions.
1. PRECAUTION (w/ Navigation System for HDD)
NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
2. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY
HINT
Refer to the instructions for Removal of the driver side knee airbag assembly See: Restraint Systems/Air Bag Systems/Air
Bag/Service and Repair/Removal and Replacement/Knee Airbag Assembly (for Driver Side)/Removal.
3. REMOVE MULTIPLEX TILT AND TELESCOPIC ECU
(a) Disconnect the 2 connectors from the multiplex tilt and telescopic ECU.
(b) Remove the bolt and the multiplex tilt and telescopic ECU.
From 08/2009
STEERING COLUMN: MULTIPLEX TILT AND TELESCOPIC ECU: REMOVAL
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system
before servicing See: Restraint Systems/Air Bag Systems/Service Precautions.
1. PRECAUTION (w/ Navigation System for HDD)
NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
2. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY
HINT