RX 350 FWD V6-3.5L (2GR-FE) (2010)
(a) Remove the nut and height control sensor link from the front lower suspension arm.
(b) Disconnect the connector.
(c) Remove the 2 nuts and front height control sensor sub-assembly.
NOTICE:
Do not drop the height control sensor. If it is dropped, replace it with a new one.
From 08/2009
SUSPENSION CONTROL: HEIGHT CONTROL SENSOR (for Front Side): REMOVAL
CAUTION:
Be sure to read Precaution thoroughly before servicing See: Suspension/Service Precautions/Suspension Control System.
NOTICE:
Before removal, make sure to disable vehicle height control by pressing the height control OFF switch and confirming that the height
control OFF indication is displayed on the meter.
HINT
*
Use the same procedure for the RH side and LH side.
*
The procedure listed below is for the LH side.
1. PRECAUTION (w/ Navigation System for HDD)
NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
3. REMOVE FRONT WHEEL
4. REMOVE FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY
(a) Remove the nut and height control sensor link from the front lower suspension arm.