RX 350 FWD V6-3.5L (2GR-FE) (2010)
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
(c) Install the height control sensor wire harness bracket to the rear suspension member with the bolt.
Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)
(d) Connect the connector.
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
3. CHECK VEHICLE HEIGHT
NOTICE:
If the height control sensor link is removed, check the vehicle height.
(a) Change the height control switch from the "NORM" position to the "HIGH" position and back to the "NORM" position.
(b) Measure the vehicle height See: Alignment/Service and Repair/Front Wheel Alignment.
4. ADJUST VEHICLE HEIGHT
NOTICE:
If the height control sensor has been replaced, be sure to adjust the vehicle height.
(a) Adjust the vehicle height See: Suspension/Testing and Inspection/Component Tests and General Diagnostics/Suspension Control System.
5. PERFORM INITIALIZATION
(a) Perform initialization See: Testing and Inspection/Programming and Relearning/Repair Instruction - Initialization.
NOTICE:
Some systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal
6. ADJUST HEADLIGHT ASSEMBLY
(a) Adjust the headlight See: Lighting and Horns/Headlamp/Adjustments.
From 08/2009
SUSPENSION CONTROL: HEIGHT CONTROL SENSOR (for Rear Side): INSTALLATION
HINT
*
Use the same procedure for the RH side and LH side.