RX 350 FWD V6-3.5L (2GR-FE) (2010)
Front Steering Knuckle: Service and Repair
Removal
Up to 08/2009
AXLE AND DIFFERENTIAL: STEERING KNUCKLE: REMOVAL
HINT
*
Use the same procedure for the RH side and LH side.
*
The procedure listed below is for the LH side.
1. REMOVE FRONT AXLE ASSEMBLY
HINT
Refer to procedures up to "Remove Front Axle Assembly" See: Suspension/Wheel Hub/Service and Repair/Front Axle
Hub/Removal.
2. REMOVE FRONT LOWER BALL JOINT ASSEMBLY See: Suspension/Ball Joint/Service and Repair/Removal
3. REMOVE FRONT NO. 1 WHEEL BEARING DUST DEFLECTOR See: Suspension/Wheel Hub/Service and Repair/Front Axle Hub/Removal
4. REMOVE FRONT AXLE HUB HOLE SNAP RING See: Suspension/Wheel Hub/Service and Repair/Front Axle Hub/Removal
5. REMOVE FRONT AXLE HUB SUB-ASSEMBLY See: Suspension/Wheel Hub/Service and Repair/Front Axle Hub/Removal
6. REMOVE FRONT DISC BRAKE DUST COVER See: Suspension/Wheel Hub/Service and Repair/Front Axle Hub/Removal
7. REMOVE STEERING KNUCKLE
(a) Place the bearing inner race (outside) on the front axle hub bearing.
Text in Illustration
(b) Using SST, a steel plate, V-blocks and a press, remove the front axle hub bearing from the steering knuckle.
SST : 09950-60010
09951-00440
09952-06010
SST : 09950-60020
09951-00750
SST : 09950-70010
09951-07100
NOTICE: