RX 350 FWD V6-3.5L (2GR-FE) (2010)
Steering Column Control Module: Service and Repair
Installation
Up to 08/2009
STEERING COLUMN: MULTIPLEX TILT AND TELESCOPIC ECU: INSTALLATION
1. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU
(a) Install the multiplex tilt and telescopic ECU with the bolt.
Torque : 2.8 Nm (29 kgf-cm, 25 in-lbf)
(b) Connect the 2 connectors to the multiplex tilt and telescopic ECU.
2. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY
HINT
Refer to the instructions for Installation of the driver side knee airbag assembly See: Restraint Systems/Air Bag Systems/Air
Bag/Service and Repair/Removal and Replacement/Knee Airbag Assembly (for Driver Side)/Installation.
From 08/2009
STEERING COLUMN: MULTIPLEX TILT AND TELESCOPIC ECU: INSTALLATION
1. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU
(a) Install the multiplex tilt and telescopic ECU with the bolt.
Torque : 2.8 Nm (29 kgf-cm, 25 in-lbf)
(b) Connect the 2 connectors to the multiplex tilt and telescopic ECU.