RX 350 FWD V6-3.5L (2GR-FE) (2010)
Text in Illustration
HINT
After adjusting toe-in, tighten the lock nut.
2. INSTALL TIE ROD ASSEMBLY RH
HINT
Perform the same procedure as for the LH side.
3. INSTALL STEERING LINK ASSEMBLY
(a) Install the steering link assembly with the 2 bolts and 2 nuts.
Torque : 70 Nm (713 kgf-cm, 51 ft-lbf)
NOTICE:
*
Make sure to tighten the bolts starting from the left side of the vehicle.
*
Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.
4. INSTALL FRONT STABILIZER BAR
5. INSTALL NO. 1 FRONT STABILIZER BRACKET LH See: Suspension/Stabilizer Bar/Service and Repair/Front Stabilizer Bar/Installation
6. INSTALL NO. 1 FRONT STABILIZER BRACKET RH
HINT
Perform the same procedure as for the LH side.
7. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE
HINT
Refer to the procedure from Install Engine Assembly with Transaxle See: Engine, Cooling and Exhaust/Engine/Service and
Repair/Removal and Replacement/Engine Assembly/Installation.
8. CONNECT TIE ROD ASSEMBLY LH
(a) Connect the tie rod assembly LH to the steering knuckle with the nut.
Torque : 49 Nm (500 kgf-cm, 36 ft-lbf)
(b) Install a new cotter pin.