RX 350 FWD V6-3.5L (2GR-FE) (2010)
REAR SUSPENSION: REAR LOWER ARM: REMOVAL
HINT
*
Use the same procedure for the RH side and LH side.
*
The procedure listed below is for the LH side.
1. PRECAUTION (w/ Air Suspension)
NOTICE:
Be sure to read Precaution thoroughly before servicing See: Service Precautions/Suspension Control System.
2. REMOVE REAR WHEEL
3. REMOVE REAR SUSPENSION ARM COVER (w/o Air Suspension)
(a) Remove the 2 bolts and rear suspension arm cover from the rear No. 2 suspension arm assembly.
4. REMOVE REAR SUSPENSION ARM COVER (w/ Air Suspension)
(a) Remove the 2 bolts and rear suspension arm cover from the rear No. 2 suspension arm assembly.
5. REMOVE REAR STABILIZER LINK SUB-ASSEMBLY See: Suspension Spring ( Coil / Leaf )/Service and Repair/Removal
6. REMOVE REAR PNEUMATIC CYLINDER ASSEMBLY (w/ Air Suspension) See: Suspension Control ( Automatic - Electronic )/Air
Spring/Service and Repair/Removal
7. REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY (w/o Air Suspension)
(a) Put matchmarks on the adjust cams and the rear suspension member sub-assembly.
Text in Illustration
(b) Using a jack and wooden block, jack up the rear No. 2 suspension arm assembly to replicate standard vehicle height conditions.
CAUTION: