RX 350 FWD V6-3.5L (2GR-FE) (2010)
5. INSTALL REAR STABILIZER LINK SUB-ASSEMBLY See: Suspension Spring ( Coil / Leaf )/Service and Repair/Installation
6. STABILIZE SUSPENSION See: Suspension Strut / Shock Absorber/Service and Repair/Removal and Replacement/Rear Shock
Absorber/Installation
7. FULLY TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY
(a) Using a ball joint lock nut wrench, fully tighten the bolt (B).
Torque : 150 Nm (1530 kgf-cm, 111 ft-lbf)
NOTICE:
*
The final torque must be applied under standard vehicle height conditions.
*
Since the stopper nut is used, tighten the bolt (B).
*
Use the formula to calculate special torque values for situations where the ball joint lock nut wrench is combined with a torque
wrench See: Service Precautions.
(b) Fully tighten the nut (A).
Torque : 150 Nm (1530 kgf-cm, 111 ft-lbf)
NOTICE:
The final torque must be applied under standard vehicle height conditions.
8. FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY
(a) Align the matchmarks on the adjust cams and rear suspension member sub-assembly.
Text in Illustration
(b) Fully tighten the nut.
Torque : 100 Nm (1020 kgf-cm, 74 ft-lbf)
NOTICE:
*
The final torque must be applied under standard vehicle height conditions.
*
When tightening the nut, keep the toe adjust cam from rotating.
9. INSTALL REAR SUSPENSION ARM COVER (w/o Air Suspension)
(a) Install the rear suspension arm cover to the rear No. 2 suspension arm assembly with the 2 bolts as shown in the illustration.