RX 350 FWD V6-3.5L (2GR-FE) (2010)
NOTICE:
Fully tighten the nut (A) after stabilizing the suspension.
(c) Temporarily tighten the rear No. 1 suspension arm assembly to the rear suspension member with the bolt (B) and nut.
NOTICE:
*
Insert the bolt with the threaded end facing the rear side of the vehicle.
*
Since the stopper nut is used, tighten the bolt (B).
*
Fully tighten the bolt (B) after stabilizing the suspension.
(d) Slowly lower the rear axle assembly.
(e) Install the rear lower suspension member stopper with the bolt and nut.
Bolt - Torque : 180 Nm (1837 kgf-cm, 133 ft-lbf)
Nut - Torque : 32 Nm (327 kgf-cm, 24 ft-lbf)
(f) Slowly lower the jack.
2. TEMPORARILY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY (w/o Air Suspension)
(a) Temporarily tighten the rear No. 2 suspension arm assembly to the rear suspension member with the rear suspension toe adjust cam
sub-assembly, the No. 2 camber adjust cam and the nut.