RX 350 FWD V6-3.5L (2GR-FE) (2010)
(2) Using a jack and wooden block, jack up the rear axle assembly LH to replicate standard vehicle height conditions.
Text in Illustration
(3) Connect the rear upper control arm assembly LH to the rear axle carrier sub-assembly LH with the bolt and nut.
Torque : 145 Nm (1479 kgf-cm, 107 ft-lbf)
NOTICE:
*
Insert the bolt with the threaded end facing the rear side of the vehicle.
*
Since the stopper nut is used, tighten the bolt.
(4) Slowly lower the rear axle assembly LH.
(h) Connect the rear upper control arm assembly RH.
HINT
Perform the same procedure as the LH side.
14. INSTALL FRAME WIRE
(a) Install the bolt and engage the clamps, and then connect the connectors to install the frame wire to the rear suspension member as shown in the
illustration.
Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)
NOTICE:
Do not twist the frame wire when installing it.
HINT
There are only the connector (A) and clamp (A) on vehicles with the HID headlight system.
15. TEMPORARILY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY LH See: Control Arm/Service and Repair/Rear Lower
Arm/Installation
16. TEMPORARILY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY RH
HINT
Perform the same procedure as the LH side.
17. INSTALL REAR STABILIZER BAR
(a) Install the rear stabilizer bar with 2 rear stabilizer bushings and 2 rear No. 1 stabilizer bar brackets with the 4 nuts.