RX 350 FWD V6-3.5L (2GR-FE) (2010)
Torque : 78 Nm (799 kgf-cm, 58 ft-lbf)
(b) Install the rear flexible hose to the rear upper control arm assembly with the bolt.
Torque : 19 Nm (192 kgf-cm, 14 ft-lbf)
NOTICE:
*
Do not twist the rear flexible hose when installing it.
*
Do not damage the rear flexible hose when reassembling it.
*
If the rear flexible hose is damaged, replace it with a new one.
(c) Install the rear flexible hose to the bracket with a new clip.
NOTICE:
*
Install the clip as far as it will go.
*
Do not twist the rear flexible hose when installing it.
(d) Using a union nut wrench, connect the brake line to the rear flexible hose.
Torque : 15 Nm (155 kgf-cm, 11 ft-lbf)
NOTICE:
*
Do not bend or damage the brake line.
*
Do not allow any foreign matter such as dirt and dust to enter the brake line.
*
Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench
See: Service Precautions.
11. ADJUST PARKING BRAKE SHOE CLEARANCE AND PARKING BRAKE PEDAL TRAVEL See: Brakes and Traction Control/Parking
Brake System/Adjustments
12. BLEED BRAKE SYSTEM
HINT
Refer to the instructions for Bleed Brake Line See: Brakes and Traction Control/Brake Bleeding/Service and Repair.
13. STABILIZE SUSPENSION See: Suspension Strut / Shock Absorber/Service and Repair/Removal and Replacement/Rear Shock
Absorber/Installation
14. FULLY TIGHTEN REAR AXLE CARRIER SUB-ASSEMBLY
(a) Fully tighten the nut.
Torque : 150 Nm (1530 kgf-cm, 111 ft-lbf)