RX 350 FWD V6-3.5L (2GR-FE) (2010)
Suspension Control Module: Service and Repair
Installation
Up to 08/2009
SUSPENSION CONTROL: SUSPENSION CONTROL ECU: INSTALLATION
1. INSTALL SUSPENSION CONTROL ECU
(a) Connect the 3 connectors.
(b) Install the suspension control ECU to the body with the 3 bolts.
Torque : 8.5 Nm (87 kgf-cm, 75 in-lbf)
NOTICE:
*
Avoid any impact to the suspension control ECU.
*
Do not drop the ECU. If it is dropped, replace it with a new one.
*
If the suspension control ECU is replaced with a new one, enter test mode and perform registration of vehicle identification
information See: Testing and Inspection/Programming and Relearning/Registration.
(c) Connect the 4WD ECU assembly connector.
(d) Install the 4WD ECU assembly with the bolt.
Torque : 8.5 Nm (87 kgf-cm, 75 in-lbf)
2. INSTALL ECU INTEGRATION BOX RH
(a) Install the ECU integration box RH with the 2 nuts and bolt.
(b) Install the No. 3 connector holder with the nut and claw.
(c) Connect each connector.