RX 350 FWD V6-3.5L (2GR-FE) (2010)
/Page-2231003.png)
Some systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
4. INSPECT SUSPENSION CONTROL SYSTEM
(a) Inspect the suspension control system See: Testing and Inspection/Component Tests and General Diagnostics/Air Suspension System/Test
Mode Procedure.
From 08/2009
SUSPENSION CONTROL: HEIGHT CONTROL SWITCH (for Luggage Compartment): INSTALLATION
1. INSTALL HEIGHT CONTROL SWITCH
(a) Connect the connector.
(b) Engage the 2 claws to install the height control switch to the deck trim side panel assembly RH.
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
3. PERFORM INITIALIZATION
(a) Perform initialization See: Testing and Inspection/Programming and Relearning/Repair Instruction - Initialization.
NOTICE:
Some systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
4. INSPECT SUSPENSION CONTROL SYSTEM
(a) Inspect the suspension control system See: Testing and Inspection/Component Tests and General Diagnostics/Air Suspension System/Test
Mode Procedure.
