RX 350 FWD V6-3.5L (2GR-FE) (2010)
/Page-2232003.png)
3. INSTALL INSTRUMENT PANEL GARNISH LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Installation
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
5. PERFORM INITIALIZATION
(a) Perform initialization See: Testing and Inspection/Programming and Relearning/Repair Instruction - Initialization.
NOTICE:
Some systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
6. INSPECT SUSPENSION CONTROL SYSTEM
(a) Inspect the suspension control system See: Testing and Inspection/Component Tests and General Diagnostics/Air Suspension System/Test
Mode Procedure.
From 08/2009
SUSPENSION CONTROL: HEIGHT CONTROL SWITCH (for Driver Seat): INSTALLATION
1. INSTALL HEIGHT CONTROL SWITCH
(a) Engage the 2 claws to install the height control switch to the lower instrument panel finish panel sub-assembly.
2. INSTALL NO. 1 SWITCH HOLE BASE See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Installation
3. INSTALL INSTRUMENT PANEL GARNISH LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Installation
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
5. PERFORM INITIALIZATION
(a) Perform initialization See: Testing and Inspection/Programming and Relearning/Repair Instruction - Initialization.
NOTICE:
Some systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
6. INSPECT SUSPENSION CONTROL SYSTEM
(a) Inspect the suspension control system See: Testing and Inspection/Component Tests and General Diagnostics/Air Suspension System/Test
Mode Procedure.
