RX 350 FWD V6-3.5L (2GR-FE) (2010)
Torque : 50 Nm (510 kgf-cm, 37 ft-lbf)
(e) Using SST and a socket wrench, fully tighten the bolt (B).
Text in Illustration
SST : 09961-00950
without SST - Torque : 50 Nm (510 kgf-cm, 37 ft-lbf)
with SST - Torque : 35 Nm (355 kgf-cm, 26 ft-lbf)
NOTICE:
*
Use a torque wrench with a fulcrum length of 345 mm (1.13 ft.).
*
This torque value is effective when SST is parallel to the torque wrench.
(f) Slowly lower the rear axle assembly.
(g) Connect the air tube to the rear pneumatic cylinder assembly.
HINT
For the connecting procedure of the tube (type 2), refer to Precaution of Suspension Control System See: Service
Precautions/Suspension Control System.
5. INSTALL REAR SUSPENSION ARM COVER See: Control Arm/Service and Repair/Rear Lower Arm/Installation
6. INSTALL REAR WHEEL
Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)
7. INSPECT FOR AIR LEAK
(a) Inspect for air leaks See: Service Precautions/Suspension Control System.