RX 350 FWD V6-3.5L (2GR-FE) (2010)
Compressor/Pump: Service and Repair
Installation
Up to 08/2009
SUSPENSION CONTROL: HEIGHT CONTROL COMPRESSOR: INSTALLATION
1. INSTALL HEIGHT CONTROL COMPRESSOR ASSEMBLY
(a) Install the 3 bushings to the height control compressor assembly.
(b) Install the bracket to the height control compressor assembly with the 3 bolts.
Torque : 5.9 Nm (60 kgf-cm, 52 in-lbf)
2. INSTALL HEIGHT CONTROL VALVE HARNESS ASSEMBLY
(a) Push the connector into the housing until a clicking sound is heard.
(b) Engage the 3 clamps.
(c) Connect the height control valve harness assembly.
3. INSTALL NO. 2 HEIGHT CONTROL TUBE
(a) Coat a new O-ring with MP grease No. 2.
(b) Install the new O-ring to the No. 2 height control tube.
(c) Connect the No. 2 height control tube to the height control compressor assembly with the holder.
HINT
For the connecting procedure of the tube (type 3), refer to Precaution of Suspension Control System See: Service
Precautions/Suspension Control System.
(d) Install the 3 clamps to the No. 2 height control tube.
4. INSTALL NO. 1 HEIGHT CONTROL HOSE
(a) Install the No. 1 height control hose to the height control compressor assembly with the clip.