RX 350 FWD V6-3.5L (2GR-FE) (2010)
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
(b) Coat 5 new O-rings with MP grease No. 2.
(c) Install the new O-rings and connect the 3 height control tubes onto the No. 1 height control valve sub-assembly.
HINT
For the connecting procedure of the tube (type 3), refer to Precaution of Suspension Control System See: Service
Precautions/Suspension Control System.
(d) Lock the 3 holders.
(e) Connect the connector and engage the clamp.
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
3. INSPECT FOR AIR LEAK
(a) Inspect for air leaks See: Service Precautions/Suspension Control System.
4. INSTALL FRONT BUMPER ASSEMBLY See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Installation
5. INSTALL HOOD CENTER CUSHION See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and Replacement/Installation
6. INSTALL COOL AIR INTAKE DUCT SEAL See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Installation
7. INSTALL ENGINE ROOM SIDE COVER See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Installation
8. INSTALL ENGINE ROOM SIDE COVER LH See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Installation
9. ADD WASHER FLUID (w/ Headlight Cleaner System) See: Wiper and Washer Systems/Windshield Washer Motor/Service and Repair/Washer
Motor (for Front Side)/Installation