RX 350 FWD V6-3.5L (2GR-FE) (2010)
(b) Disconnect the connector.
(c) Remove the 2 nuts and front height control sensor sub-assembly.
NOTICE:
Do not drop the height control sensor. If it is dropped, replace it with a new one.
Up to 08/2009
SUSPENSION CONTROL: HEIGHT CONTROL SENSOR (for Front Side): INSTALLATION
HINT
*
Use the same procedure for the RH side and LH side.
*
The procedure listed below is for the LH side.
1. INSTALL FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY
(a) Install the front height control sensor sub-assembly with the 2 nuts.
Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)
NOTICE:
Do not drop the height control sensor. If it is dropped, replace it with a new one.
(b) Connect the connector.
(c) Install the height control sensor link onto the front lower suspension arm with the nut.
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)