RX 350 FWD V6-3.5L (2GR-FE) (2010)
(c) Connect each connector.
3. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Installation
4. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY See: Restraint Systems/Air Bag Systems/Air Bag/Service and
Repair/Removal and Replacement/Knee Airbag Assembly (for Front Passenger Side)/Installation
5. INSTALL INSTRUMENT PANEL GARNISH RH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Installation
6. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Installation
7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service
and Repair/Removal and Replacement/Installation
8. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Installation
9. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service
and Repair/Removal and Replacement/Installation
10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Installation
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
12. INSPECT SUSPENSION CONTROL SYSTEM
NOTICE:
If the suspension control ECU is replaced with a new one, perform registration of vehicle identification information.
(a) Inspect the suspension control system See: Testing and Inspection/Programming and Relearning/Registration.
13. ADJUST VEHICLE HEIGHT
NOTICE:
If the suspension control ECU has been replaced, be sure to adjust the vehicle height.
(a) Adjust the vehicle height See: Testing and Inspection/Programming and Relearning/Calibration.
14. PERFORM INITIALIZATION
NOTICE:
Some systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
(a) Perform initialization See: Testing and Inspection/Programming and Relearning/Repair Instruction - Initialization.
15. CHECK SRS WARNING LIGHT