RX 350 FWD V6-3.5L (2GR-FE) (2010)
2. INSTALL REAR LOWER COIL SPRING INSULATOR
(a) Install the rear lower coil spring insulator to the rear No. 2 suspension arm assembly.
3. INSTALL REAR COIL SPRING
(a) Set the rear coil spring to the rear No. 2 suspension arm assembly.
Text in Illustration
NOTICE:
Set the rear coil spring so that the identification mark is positioned as shown in the illustration.
(b) Using a jack and wooden block, slowly jack up the rear No. 2 suspension arm assembly.
Text in Illustration
(c) Install the rear No. 2 suspension arm assembly and rear coil spring with the bolt (B) and nut.
Torque : 100 Nm (1020 kgf-cm, 74 ft-lbf)
NOTICE:
*
Insert the bolt (B) with the threaded end facing the front side of the vehicle.
*
Since the stopper nut is used, tighten the bolt (B).
*
Fully tighten the nut (A) after stabilizing the suspension.
4. INSTALL REAR STABILIZER LINK SUB-ASSEMBLY