RX 350 FWD V6-3.5L (2GR-FE) (2010)
Control Module: Service and Repair
U660F Automatic Transaxle
Components
U660F AUTOMATIC TRANSMISSION / TRANSAXLE: TCM: COMPONENTS
Up to 08/2009
U660F AUTOMATIC TRANSMISSION / TRANSAXLE: TCM: REMOVAL
NOTICE:
If automatic transmission parts are replaced, refer to Parts Replacement Compensation Table to determine if any additional
operations are necessary See: Transmission Control Systems/Service Precautions/U660F Automatic Transaxle System.
1. PRECAUTION (w/ Navigation System for HDD)
NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
2. REMOVE ENGINE ROOM SIDE COVER See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Removal
3. REMOVE ENGINE ROOM SIDE COVER LH See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Removal
4. REMOVE COOL AIR INTAKE DUCT SEAL See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Removal
5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.